Light-emitting diodes (LEDs) are often used with a voltage source from a power-supply output voltage. The output voltage increases until the current through the LEDs reaches the value of the ...

Let’s say you want to blink an LED. You might grab an Arduino and run the Blink sketch, or you might lace up a few components ...

The mystery of adding LED lights to a modern BMW with CAN Bus (Controller Area Network) electrical system is easy to resolve. The “smart” CAN Bus smells a rat when you pop in an LED brake light or ...

The basic circuit illuminates up to ten LEDs in sequence, following the rhythm of music or speech picked-up by a small microphone. The expanded version can drive up to ten strips, formed by up to five ...

LEDs are more efficient than incandescent lights and can last 100 times longer, but they require specialized electronic-drive circuits to avoid overstress conditions. The main operating parameter is ...

To calculate the resistance of the series resistor required, we need to look at the current and voltage values recommended by the LED manufacturer. Suppose a manufacturer recommends a maximum voltage ...

If you got your start in electronics sometime after 1980 your first project might well have been to light up an LED. Microcontroller projects often light up an LED, too, and a blinking LED is ...

Microcontroller port pins can typically be driven either high or low, or else be put into an "input" or high-impedance state. This circuit uses the three states to drive two separate LEDs with one ...

Guest columnist Faraz Hasan, marketing and business development manager at Tyco Electronics Circuit Protection Products says that LEDs can require overcurrent protection despite built-in safety ...

With a 4k1 collector resistor and 16mA drive into the led, the chosen (read ‘cheapest on ebay’) 6N135 is supposed to beat 1.5μs for both turn on and turn off, with typical figures of 90ns and 800ns.