This sensor device is built to measure the amount of current being used, especially in power supplies as the design is based on Arduino. The main component used is the ACS712 sensor from Allegro ...

Before opening the Arduino software, wire up the Arduino according to the circuits page using the 8MHz minimalist breadboard circuit but with a 10k pull-up resistor on the reset pin (physical pin 1).

Makers, developers and hobbyists that are looking for a virtual breadboard might be interested in a new application and service created by James Caska based in Amsterdam. The PCB Direct virtual ...

Here’s a no-PCB Arduino that doesn’t obscure the DIP footprint of the AVR chip. It’s built on an ATmega88 chip, and includes a programming header, reset button, a couple of filtering caps, and an LED.

I recently had to build an infrared close proximity sensor that could tell if something was dropped in a parcel delivery drop box. After some searching, I ended up using a microcontroller and a piece ...