Some 1.5 v LED flasher circuits are available on the internet and we like to present you four of them. The flasher circuits below operate on a single 1.5 volt battery. The circuit on the upper uses ...

This circuit was designed to provide that continuous light lamps already wired into a circuit, become flashing. Simply insert the circuit between existing lamp and negative supply. Especially suited ...

With this circuit you can flash some LEDs for your rc airplanes or any other uav just like the real strobe navigation lights ...

Let’s say you want to blink an LED. You might grab an Arduino and run the Blink sketch, or you might lace up a few components ...

LTspice is a free version of spice from Linear Technology, and it is delightfully easy to use, intuative, and seems to work rather well. Note, there is a flasher version 3 Current through component ...

Tito] entered a Self-Charging LED Flasher into the Component Abuse Challenge. It’s a simple re-build of a design by the ...

An LED is commonly used as a "power on" indicator for many electronic devices. For the LED to produce discernible visible light in daylight, the forward-bias current needs to be in the moderate range ...

Everything was going fine until we got the LEDs installed and went to test the turn signals in the driveway. Nothing-no blinking, no flashing, no nothin'. Perplexed, we retraced our steps, ...

The flashing is thanks to LEDs with a built-in, integrated flashing circuit and the nasty noise comes from a piezoelectric buzzer — both are available from electronics stores that sell ordinary LEDs.

With cycling safety in mind, I bought a pair of low power red LED things that replace the bungs in the end of drop handlebars. They are a neat way to get a bit of extra visibility – and to give a ...